SEC. 93.0202. EXCEPTIONS, PERMITS NOT REQUIRED. (a) No permit shall be required in the following cases: (Amended by Ord. No. 172,593, Eff. 6/28/99, Oper. 7/1/99.) 1. Electric wiring expressly declared to be exempt from permit requirements of this Code by any other sections of the Code or by any other provisions of the LAMC. (Amended by Ord. No. 184,692, Eff. 12/30/16.) 2. Wiring for temporary theater sets on the theater stages or temporary motion picture or television sets on any property belonging to or under the control of the City, privately owned studios, theaters, or similar locations designed for that usage. (Amended by Ord. No. 184,692, Eff. 12/30/16.) 3. Installation of any portable motor or other portable appliance energized by means of a cord or cable having an attachment plug end, when that cord or cable is permitted by this Code. 4. Repair or replacement of fixed motors or fixed appliances, supplied by branch circuits not exceeding 20 amperes and not exceeding 240 volts nominal, of the same type and rating in the same location where not located in an area classed as " hazardous " under CEC Article 500. (Amended by Ord. No. 184,692, Eff. 12/30/16.) 5. Festive temporary decorative lighting in dwelling occupancies only, for a period not to exceed 90 days. (Amended by Ord. No. 179,325, Eff. 12/10/07, Oper. 1/1/08.) 6. Repair or replacement of current-carrying parts of any switch, contactor or control device. (Amended by Ord. No. 173,704, Eff. 1/27/01.) 7. Reinstallation of attachment plug receptacle, but not the outlets for it. 8. Replacement of any overcurrent device of the same rating and in the same location. 9. Replacement of gas tube electrodes, transformers, tubes, drivers and power supplies with the same original manufactured parts having the same size, type, capacity and ratings for electric signs, or luminaries. (Amended by Ord. No. 181,561, Eff. 3/22/11.) 10. Taping of joints. 11. Removal of electric wiring. 12. Temporary wiring for experimental purposes in suitable experimental laboratories. 13. The following electrical wiring: (Amended by Ord. No. 184,692, Eff. 12/30/16.) (i) Non-required signaling circuits supplied by an approved Class 2 limited power source, capable of supplying not more than 30 volts and 100 volt-amperes; and (ii) Non-required communication circuits which have the power limited in accordance with CEC Section 725.121;