Sec. 13B.5.2. | Los Angeles City Law Search

liant or non-compliant based on whether it meets the standards and definition of one of the roof form options allowed by the applied Frontage District (Part 3B.). E. Relief 1. Up to a 10 percent reduction in the total required roof area having an allowed roof form may be granted in accordance with Sec. 13B.5.2. (Adjustment). | 3-134 [ FORM - FRONTAGE - STANDARDS ] [ USE - DENSITY ] Div. 3D.11. (Roof Design) Sec. 3D.11.1. (Roof Form) Established by Ord. 188,418, Eff. 01/20/2025, Oper. 01/27/2025 City of Los Angeles Zoning Code Chapter 1A 2. A deviation from roof form dimensional standard up to 10 percent may be granted in accordance with Sec. 13B.5.2. (Adjustment). 3. Deviation from any roof form standard may be granted as a variance in accordance with Sec. 13B.5.3. (Variance). | 3-135 [ FORM - FRONTAGE - STANDARDS ] [ USE - DENSITY ] Div. 3D.11. (Roof Design) Sec. 3D.11.2. (Roof Materials) Established by Ord. 188,418, Eff. 01/20/2025, Oper. 01/27/2025 City of Los Angeles Zoning Code Chapter 1A SEC. 3D.11.2. ROOF MATERIALS A. Intent The intent of the standards of this Section (Roof Materials) is to ensure that a building's roof finishing materials contribute to the established architectural character of surrounding neighborhoods or districts. B. Applicability This Section (Roof Materials) applies to new construction, a major remodel, or an exterior modification. When roof materials standards apply, the standards apply to all portions of a required primary roof form pursuant to Sec. 3D.11.1. (Roof Form) on any frontage lot line-facing buildings on a lot. C. Standards Only roof materials specified by the applied Frontage District (Part 3B.) shall be used to finish an applicable roof. D. Measurement Roof materials are measured as compliant or non-compliant based on whether all applicable roofs meet the roof materials standards. E. Exceptions Roof material standards do not apply to accessory roof forms. F. Relief 1. Up to a 10 percent reduction in the total required roof